Schwinn a10 - Replacing the Console Batteries; Machine Type Switch

23
Replacing the Console Batteries
If the Battery Indicator comes on, replace the batteries in the back of the console with fresh batteries. Make sure the
batteries point in the +/– direction shown in the battery bay.
Note:TheconsoleusesDsizebatteries(LR20).Ifyouuserechargeablebatteries,theoptionalpoweradapterwillnot
recharge the batteries.
!
Donotmixoldandnewbatteries.
Donotmixalkaline,standard(carbon-zinc),orrechargeable(Ni-Cd,Ni-MH,etc)batteries.
Machine Type Switch
The Machine Type switch (N) on the Console is preset at the factory to B (bike) or E (elliptical). If you replace the console,
it will possibly be necessary to set the switch for your machine. After you set the switch, it is necessary to turn the power
off and then turn it back on to start the new mode of operation.
NOTICE:MakesurethattheMachineTypeissetcorrectlytogivemoreaccuratecalculationsforDistance,Speed
and Calories values.
X4
+
–
N