PN 10795T 4
ENVIRONMENTAL REQUIREMENTS
This product is intended for indoor use at altitudes up to 2000 meters, Pollution Degree 2 in accordance
with IEC 664 and transient overvoltages according to Installation Categories (Overvoltage Categories) II.
Note that each of the above detectors will not pass the IEC 801 Publication, Part 3, Radiated
Electromagnetic Field Requirements. The system, meter and detector, is designed to measure radiation
within the test's radiation band. The detectors were held outside the radiated electromagnetic field during
this test. It is up to the user to be aware of RF fields present during measurements and their effects if any
on those measurements.
CE Mark Certification
All of the power meters listed in this manual have been certified for the European CE mark.
VECTOR™ H410 POWER METER SPECIFICATIONS
The Models H410 and H410D are identical to each other in every respect except the analog meter. The
H410 has both an analog and digital display. The H410D has only a digital readout. All references to the
H410 are intended to include the H410D except where noted. Also, the words "indicator" and "meter" are
synonymous. Specifications are summarized in Table 1.
UNPACKING
The meter, detectors, and accessories are shipped in custom packing materials. All packing materials
should be saved for future damage free shipments.
If using the AC battery charger, verify that the electrical outlet is compatible with the charger. When
using a charger, the H410 will operate with or without batteries installed. However, if batteries are
installed, they must have a minimum charge of approximately 1 hour before the H410 will turn on, even
if the AC battery charger is used.
The H410 also runs off of four AA rechargeable batteries, which provide approximately 6 hours of usage
before requiring recharge. To recharge the batteries, connect the charger to the power meter and the
appropriate electrical outlet. Allow 16 to 20 hours for a full charge.
To Next Page
Loading...