PN 10795T 6
CHANGING OR INSTALLING BATTERIES
Warning: Use only Ni-MH or NI-Cad rechargeable batteries. If non-rechargeable batteries are used with
the battery charger the batteries may burst and cause damage to you or the power meter.
Note: Dispose of used batteries according to local regulations.
To install batteries refer to Figure 2 and proceed as follows:
1. Loosen the screw holding the battery compartment cover.
2. Remove the old batteries if necessary.
3. Observing the polarity, install the new batteries.
4. Replace the cover and charge the batteries for 16 to 20 hours.
Figure 1. H410 Meter Front Figure 2. H410 Meter Back
To Next Page
Loading...