• Connect the power cable.
• Install the platform.
• Switch ON the instrument.
• The instrument begins self-checking.
• When initialization is over, LED displays the last
running values of speed and timer.
• Rotate the speed/timer control knob to set target speed.
a. Press the mode switch button to choose the speed
or timer setup interface. When the character of LED
display is flashing, rotate the parameter adjusting knob
to set the target parameter. Press the knob to start the
motion.
b. During operation, motion can be stopped at any
time by pressing the parameter adjusting knob. If the
knob is pressed again, motion will start again and the
timer will continue to countdown. When the timer
reaches zero, the unit will be automatically halted.
c. When the timer is set to be 00:00, start the
continuous motion.
• Switch OFF the instrument.
!
If these operations above are normal, the instrument is
ready to operate. If not, the instrument may be damaged
during transportation, please contact technical support of
manufacturer/supplier.
6. Faults
• When switched ON, the instrument does not work
! Check whether the power cable is connected
• Motor!speed!cannot!reach!set!value!
! Check whether it is overloaded
7. Maintenance and Cleaning
• Proper maintenance can keep instrument working
properly and lengthen its lifetime.
• Do not spray cleanser into the instrument when
cleaning.
• Do not remove the power line when cleaning. Only
use recommended cleansers:
To Next Page
Loading...
