Scion Instruments 436-GC - Programmable Temperature Vaporizing (PTV) Injector

Page: 105
436-GC/456-GC
710 Injectors
SCION Instruments
436-GC/456-GC Service Manual Revision B February 2019
Programmable Temperature Vaporizing (PTV) Injector
1. a. Injector Nut CP8400/8410 (392595401; default)
b. Injector Nut (394966601)
Injector Nut Wrench (390842300)
2. Automatic Start Switch (390820601)
3. Septum, 11.5 mm
BTO (lowest bleed, CR298777)
Marathon (Auto sampler, CR239787)
Advanced Green 3 (general purpose, CR246725)
4. Septum Support (391867600)
5. Insert Ferrule (392534201)
6. Glass Insert, default 392611945
Siltek RT217092145
7. Injector Body
Pneumatic Type Stainless Steel Inert Steel
EFC
392544001
392544011
Manual Pneumatics
392559601
392559611
Cryo tube LCO
2
(392557901)
Cryo tube LCN
2
(392557902)
8. Column Ferrule, see table below
9. Bottom Nut (394955100)
(CP742351 Brass 1/16”)
Temperature Probe (392537401)
Heater, 120V 100W- 392542501
230V 100W- 392542502
Column ID
Holes
Teflon
Max 250°C
Vespel
Max 350°C
40% Graphite
/60% Vespel
Max 400°C
Graphite
Max 450°C
SilTite
Metal, GC/MS
0.18 mm ID and smaller
1
CR212103
CR213103
0.25 mm ID
1
CR214104
CR212104
CR213104
CR211104
2
CR213124
0.25 mm ID and smaller
1
SG073300
0.32 mm ID
1
CR212105
CR213105
CR211105
SG073301
2
CR213125
CR211125
0.53 mm ID
1
CR214108
CR212108
CR213108
CR211108
SG073302
1a
1b
2
3
4
5
6
7
8
9