Scion Instruments 436-GC - How to Set the IP Address in Compass-CDS Workstation Using BOOTP

436-GC/456-GC
910 Technical information
Page: 188
SCION Instruments
436-GC/456-GC Service Manual Revision B February 2019
HOW TO SET THE IP ADDRESS IN COMPASS-CDS WORKSTATION USING BOOTP
1) Select the network card of your computer and write down the IP address of the card.
2) As “example” IP address network card : 10.2.128.1 or can be determined by the customer.
3) Subnet mask and Gateway can be determine by the customer, if not then change the Subnet
mask to a value that is compatible with the instrument.(see Card1)
4) Open compassCDS configuration manager and select in the TOOLS bar.
5) Select in TOOLS bar the BootP configuration.
6) Make sure that the network interface is compatible with the GC settings.