SciQuip INCU-C series - Page 16

INCU-C Series V2018.1.1
16
End temperature of the first segment.
Retaining time for the programmed temperature in the first step
segment segment.
Setting for segment 2. Follow the same procedure for each of the
following segments (10 in total).
Special attention:
To pause the current program, press “R/H/S” key, and press again to
resume.
To abort the program any time press the “R/H/S” key for 3 seconds.
To continue press the again “R/H/S” key to run it again from the start.
Programme parameter
Set Segment 1
Ramp end
temperature
37.0°C
Programme parameter
Set Segment 1
Hold time
10.0 min
Programme parameter
Set Segment 2
Ramp time
0.1min