3. Power-off recovery
This equipment has power-off recovery function. When the external power is
recovered after a sudden cut off and the deviation of temperature inside is within
2 , the equipment can automatically recover to run according to the originally
designed programme.
4. Setting of Graphic chart to display the time
Press the SET key to enter the password 8 , Press the Set key again to enter
into setting of graphic chart display function. Press the Increase or Decrease key to
modify the timer.. Press the Set key to confirm the new setting.
9.Operation and Switch off
8
SETSET SETSET
SETSET
Change/Confirm
button
Hold on for 3 seconds
Increase
button
Change/Confirm
button
Increase
button
Decrease
button
Graphic chart recording time value
Change/Confirm
button
Simplified instruction on the setting of Graphic chart recording time
12
1.When the above setting is finished, press the Operating button and the equipment runs
according to the designed programme, the operating indicator RUN turns on.
2.When the equipment is in the state of temperature control or programme control, the heating
indicator lights or twinkles means the heating is connected and it is normal.
3.When in operation, if you need to change parameter, press the Operating button to stop
running, change the parameter after the operating indicator turns off.
4.When operating time increases in operation, twinkles by second. When operating time reaches the
preset value, heating output will be stopped, the operating indicator turns off. At this time, the power
control transformer is still connected to power supply, so turn off the main switch on the right side of
the equipment to switch off the equipment.
9.Operation and Switch off
AC.220~240V 50/60Hz
Heater
Blower
Control unit
DC power unit
Temperature
measuring unit
Display unit
Keyboard
10.Electric theorem
13
5.Air ventilation Adjustment
For discharge the excess humidity evaporation, the unit
is equipped with a adjustable air ventilation.
Turn the knob clockwise located on the right sidewall
to open up air vent, or anti-clockwise to close. Air vent
located on the back wall.
To Next Page
Loading...
Need help?
General
