SCOTT AIR-PAK 75i 2.2

To Next Page

Page 1 of 44

P/N 595236-01 Rev. B 10/11

Typical configuration of SCOTT AIR-PAK 75i SCBA's shown.

Appearance of respirators may vary depending on optional and accessory equipment.

OPERATING & MAINTENANCE INSTRUCTIONS

SCOTT AIR-PAK

75i

Industrial Pressure-Demand

Self Contained Breathing Apparatus (SCBA)

Models

2.2 / 4.5

TYPICAL AIR-PAK 75i SCBA

3000, and SURESEAL are registered and/or unregistered marks of Scott Technologies, Inc. or its affiliates.

WARNING

IMPROPER USE OF THIS RESPIRATOR MAY RESULT IN PERSONAL INJURY OR DEATH. IMPROPER USE IN-

CLUDES, BUT IS NOT LIMITED TO, USE WITHOUT ADEQUATE TRAINING, DISREGARD OF THE WARNINGS AND

INSTRUCTIONS CONTAINED HEREIN, AND FAILURE TO INSPECT AND MAINTAIN THIS RESPIRATOR. READ AND

UNDERSTAND ALL INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE OR SERVICE THIS EQUIPMENT.

THIS RESPIRATOR IS INTENDED TO BE USED ONLY IN CONJUNCTION WITH AN ORGANIZED RESPIRATORY

PROTECTION PROGRAM WHICH COMPLIES WITH THE REQUIREMENTS OF "PRACTICES FOR RESPIRATORY

PROTECTION," Z88.2 AVAILABLE FROM AMERICAN NATIONAL STANDARDS INSTITUTE INC., 1430 BROAD-

WAY, NEW YORK, N.Y., 10018, OR THE REQUIREMENTS OF OSHA SAFETY AND HEALTH STANDARD 29 CFR

1910 PARAGRAPH 134 AVAILABLE FROM THE U. S. DEPARTMENT OF LABOR, OCCUPATIONAL SAFETY

AND HEALTH ADMINISTRATION, OR OTHER PERTINENT NATIONALLY RECOGNIZED STANDARDS, SUCH

AS THOSE PROMULGATED BY THE U. S. COAST GUARD OR THE DEPARTMENT OF DEFENSE.

TRI-SLIDE

BUCKLE

AIR SAVER

SWITCH

PURGE

VALVE

REMOTE

PRESSURE

GAUGE

BREATHING

REGULATOR

CYLINDER

VALVE

Need help?

Do you have a question about the SCOTT AIR-PAK 75i 2.2 and is the answer not in the manual?

Summary

SCBA System Description and Training

Essential Training for SCBA Operation

User must be trained in SCBA use and program compliance for safe operation.

Choosing the Correct SCBA Equipment

SCBA Service Life Factors

Heads-Up Display Operation Guide

Facepiece Fitting and Fit Testing Procedures

Regular Operational Inspection

Breathing Air Cylinder Inspection

Respirator Component Inspection

Facepiece Component Inspection

SCBA Operational Testing

Verifying the correct function of alarms, pressure gauges, and air supply.

Using the SCBA Respirator

Donning and Preparation for Use

Steps to prepare and don the SCBA for entry into hazardous atmospheres.

Facepiece Donning Procedures

Detailed instructions for correctly putting on and securing the facepiece.

Initiating Respirator Use

Final checks before starting respirator operation in a hazardous environment.

Respirator Use Monitoring

Procedures for monitoring air supply and ensuring safety during respirator use.

Terminating SCBA Use

Resuming SCBA Use

RIC UAC Emergency Air Supply

Emergency SCBA Operation Procedures

Low Temperature SCBA Operation

SCBA Cylinder Replacement

SCBA Cleaning and Storage

Periodic SCBA Testing Schedule

SCBA Battery Replacement

SCBA Cautions and Limitations