SCOTT CX 100 DP User Manual

GB 7
Care and maintenance
To clean the casing, unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and
water solution only. Do not use benzene, thinner or similar chemicals to clean the casing.
MAINTENANCE
Radio
Tuning range FM: 87.5 – 108 MHz
MW: 522 – 1620 kHz
Antennas FM: telescopic
MW: built-in ferrite bar
General
Output power 2 x 80mW
Power consumption 3.5 W
Speakers (2x) 2” diameter
8 Ohm impedance
Power source:
AC power cradle Input: AC 230V ~ 50Hz
Output: DC 4.5V
Batteries DC 4.5V: 3 x 1.5V UM3/ “AA” batteries
Dimensions 80 (H) x 190 (W) x 36 (D) mm
Weight
Unit 0.24 Kg
Unit with AC power cradle 0.5 Kg
Note: Due to continuing improvements, the technical specications are subject to change without notice.
TECHNICAL SPECIFICATIONS
If at any time in the future you should need to dispose of this product, please note that waste
electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)
CR25-SCOTT-AMFM-ENG.indd 8 12/11/2008 16:41:16

SCOTT CX 100 DP Specifications

Radio

FM tuning range	87.5 – 108 MHz
MW tuning range	522 – 1620 kHz
FM antenna type	telescopic
MW antenna type	built-in ferrite bar

General

output power	2 x 80mW
power consumption	3.5 W
speaker diameter	2 inches
speaker impedance	8 Ohm

Power

AC power input	AC 230V ~ 50Hz
DC power output	DC 4.5V
battery power	DC 4.5V: 3 x 1.5V UM3/ “AA” batteries

Weight and Dimensions

dimensions	80 (H) x 190 (W) x 36 (D) mm
unit weight	0.24 Kg
unit weight with AC power cradle	0.5 Kg