Service Mower - 39
SERVICE MOWER
Keep original bevel (A) when grinding.
Blade should have 0.40 mm (1/64 in.) cutting edge (B) or
less.
Balance blades before installing.
Balancing Blades
1. Clean blade.
2. Put blade on nail in a vise. Turn blade to horizontal
position.
3. Check balance. If blade is not balanced, heavy end of
blade will drop.
4. Grind bevel of heavy end. Do not change blade bevel.
c
CAUTION: Avoid injury! Mower blades are
sharp. Always wear gloves when handling
mower blades or working near blades.
A
B
To Next Page
Loading...
