Scotts SP6211 - OPERATING; Controls and Adjustments

Operating - 5
OPERATING
Operating
Engine Controls
A - Primer Bulb
Handle Controls
A - Blade Control Lever
B - Traction Clutch Lever
C - Starter Handle
D - Travel Speed Lever (SP6213)
Handle and Cutting Height Controls
A - Fold Handle Knobs
B - Handle Height Knobs
C-CuttingHeightLevers
ADJUSTMENTS
Adjusting Cutting Height
NOTE: Adjust both levers to same height except for
LOWEST cutting height (A). This adjustment improves
mulching performance at lowest cutting height:
• Put front wheel levers in 25 mm (1 in.) notch: First
rear notch.
• Put rear wheel levers in 38 mm (1-1/2 in.) notch:
Second rear notch.
To help move rear wheel lever:
1. Lift lower handlebar slightly with one hand to take some
weight off wheel.
2. Move height adjustment lever to desired position with
other hand.
MX1568
A
M93034
B
A
C
D
cCAUTION: Avoid injury! Before you adjust
cutting height:
STOP ENGINE.
M96540
B
A
A
B
C
C