TB-9024 Page 7 of 7
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
SCS - 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website: StaticControl.com
This numerical reference should not be construed
as a representation regarding the product’s life or
an extension of a product warranty. In the event any
product is proven not to conform with SCS’s Regulatory
Information Sheet, then SCS’s entire liability and
buyer’s exclusive remedy, will be at SCS’s option either:
(i) replacement of product with a conforming product,
or (ii) refund of the purchase price paid by buyer for
each nonconforming product, within a reasonable time
after written notification of said nonconformance and
return of said product to SCS. SCS shall not under any
circumstances be liable for direct, incidental, special, or
consequential damages (including but not limited to loss
of profits, revenue, or business) related to or arising out
of this certification, including, the use, misuse or inability
to use the product. Unless stated otherwise in writing,
the foregoing language cannot be waived, modified, or
supplemented in any manner whatsoever.
This is the EU symbol for equipment that is
covered under the Waste from Electrical and
Electronic Equipment (WEEE) directive per
CENELEC Specification 5041. It indicates that
certain products should not be discarded in the trash,
but rather should be recycled. This applies to all
electronic pluggable and battery powered products.
FCC
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation.
Part or Component Name
Hazardous Substances or Elements
(Pb) (Hg) (Cd) (CrVI) (PBB) (PBDE)
Termination in capacitor 0603 X O O O O O
Solder in diode X O O O O O
Finish in diode X O O O O O
Terminations in PCBs X O O O O O
Terminations in resistors 0603 X O O O O O
Plating in resistors 0603 X O O O O O
Resistor ink in potentiometer X O O O O O
Solder in instrument X O O O O O
Solder in IC X O O O O O
Solder in buzzer X O O O O O
Audio jack X O O O O O
O: Indicates that this hazardous substance contained in all of the homogeneous materials
for this part is below the limit requirement in the SJ/T11363-2006.
X: Indicates that this hazardous substance contained in at least one of the homogeneous
materials used for this part is above the limit requirement in the SJ/T11363-2006.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Industry Canada
This Class A digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe A est conforme á la
NMB-003 du Canada.
Limited Warranty, Warranty Exclusions, Limit
of Liability and RMA Request Instructions
See the SCS Warranty -
StaticControl.com/Limited-Warranty.aspx
To Previous Page
Loading...