Precautions for Use / Vorsichtsmaßnahmen für den Gebrauch / Précautions d'emploi /
Precauzioni per l'uso / Precauciones de uso / Środki ostrożności dotyczące stosowania
7
EN
1. Before use, please ensure that RA is parallel to the X-axis of the engraving machine (P07), otherwise the engraving patterns may deform
2. When using the roller mode, if the roller loses step, the belt tension needs to be adjusted (P40).
3. When using the chuck, t to make the top of the workpiece adhere to the inner plane of the chuck as much as possible, and tighten the chuck. If
necessa, the tail can be xed with tailstock to prevent the workpiece from falling o during the engraving process.
4. When engraving a conical object, it is necessa to adjust the chuck angle with a mini level to keep the engraving suace level and ensure the
engraving eect (P38).
5. When using the chuck mode, each time the material is changed, the material parameters need to be updated again in the “Rota Setup” window
(P11).
6. When not using SCULPFUN RA, it is necessa to reset the parameters written to the motherboard and turn o the “Enable Rota” in the “Rota
Setup” window (P12).
7. The engraved pattern is mirror image. You can set up a reverse Y-axis motor (P10), or rotate the RA left and right (P13), or mirror drawings.
8. If this is your rst time using this product, please read the attached instructions carefully to improve your using experience. SCULPFUN is not
responsible for any damages caused by the failure to follow the instructions and requirements for the use of this product or the incorrect use of this
product.
9. SCULPFUN has carefully checked the contents of the manuals, but there may still be errors or omissions. We are committed to continuously
improving the functionality and quality of our products and seices and therefore resee the right to make changes to the manuals and to the
products or software described in the manuals without prior notice.
43
To Next Page
Loading...
