SDC Emlock 1500 Series - User Manual

The 1500 Series Emlock is mounted to the underside of the header, on the stop side of the door. A Top Jamb mounting kit (optional)
can be used when mounting on the hinge side of the door. (Fig. 2D)
The armature is mounted to the door. A hardware kit is provided allowing the armature to pivot on it’s center point.
LOCK MOUNTING
1. Locate the paper Template and fold along the dotted line. Place the folded edge of the template against the door, header stop, and
vertical stop opposite the hinge side of the door (see Fig. 1). Tape in place at this position.
P:\INST INSTRUCTIONS\EMLOCKS\INST-1500 REV G.3 10-24 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
INSTALLATION INSTRUCTIONS
1500 SERIES EMLOCK®
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
HINGE SIDE OF FRAME
(OPPOSITE FROM LOCK)
PAPER TEMPLATE
HINGE SIDE OF FRAME
(OPPOSITE FROM LOCK)
PAPER TEMPLATE
2. Prior to drilling, inspect to see if any of the holes cannot be drilled due to the frame or door configuration. A Filler Plate or Angle
Bracket may be required as shown in Figures 2B and 2C (see page 6 for part specifications). Figure 2A is a typical regular install.
FIG. 2A
Regular
FIG. 2A
Regular
FIG. 2B
With Filler Plate
Filler Plate
FIG. 2B
With Filler Plate
Filler Plate
FIG. 2D
Top Jamb Bracket
Adjustable
TJ Bracket
Standard
Lock
FIG. 2D
Top Jamb Bracket
Adjustable
TJ Bracket
Standard
Lock
FIG. 2C
With Angle Bracket
Angle
Bracket
FIG. 2C
With Angle Bracket
Angle
Bracket
FIG. 2A
Regular
FIG. 2B
With Filler Plate
Filler Plate
FIG. 2D
Top Jamb Bracket
Adjustable
TJ Bracket
Standard
Lock
FIG. 2C
With Angle Bracket
Angle
Bracket
FIG. 1

SDC Emlock 1500 Series Specifications