Operation & Maintenance Manual──LG968 /969Wheel Loader
20
z Do not turn on ramp. Do not drive crossing the ramp
or change direction which may induce turn over.
z Never turn on ramp until go to the plain ground. Slow the speed and use small turning angle
when working on abrupt sidehill, dyke or ramp.
z Go up and down the ramp if possible, try not drive through alleyway or footway.
z Choose proper gearshift before go down slopes and never shift the speed during going down
slopes.
z Do not brake on ramp because the center of gravity is on the front tire or rear tire.
z Use speed I when driving on ramp with full load. Go forward when drive upward the ramp, go
backward when drive downward the ramp. Do not turn.
z Brake slowly when driving downward the ramp, do not use empty speed control for gear control
lever.
z Go down the ramp slowly, never stop the engine.
z If engine stop on the ramp (slope is less than 15°)，step the brake padel immediately and low the
bucket to the ground to help brake, put the gear control lever to the middle position, and then
restart engine.
z Drive with load, the bucket should face the high
direction of the ramp all the time, which means go
up forward and go down backward.
5.9 Towing
△
! WA RN I N G
Injury, even death could result if a disable machine is towed
incorrectly.
To Next Page
