Operation & Maintenance Manual──LG968 /969Wheel Loader
66
△
! NOTICE
z Never run at high speed if the machine runs at slope or
uneven ground.
z Select proper transmission when go down the slope and
never change the transmission at that time.
z Never run over speed going down the slope, and use the
brake pedal to slow the speed.
3.3.2 Gearshift, Changing between Forward and Backward
z Press the accelerograph a little bit during change transmission to prevent too much impulsion.
z It is best the change the running direction (change from forward to backward or from backward
to forward) after stop the machine to get the best comfort and prolong the life utmost.
z No need to stop and brake during running. Release the accelerograph and operate the
transmission lever at the same time when change the speed from low to high; when change the
speed from high to low, release the accelerograph first and then change the transmission slowly.
3.3.3 Turning
z Turn the steering wheel the same as the wished turning direction of the machine to turn.
z The machine is centered at swivel pin, the front and rear frame will bend to turn.
△
! WARNING
z Never turn suddenly or turn on the slope at high speed.
z The machine can not turn if the engine stops
3.3.4 Braking
z Never put your foot on the brake pedal unless necessary.
z Never press the brake pedal again and again unless necessary.
z Never try stopping the engine and put the gear control lever at neutral position during going
down the slope.
z Never use left brake pedal (if left and right brake pedals are assembled) during driving on ramp
to prevent the power being cut off to induce danger.
To Next Page
Loading...
