To Next PageTo Next Page
Need help?Do you have a question about the SDRPLAY SDRuno and is the answer not in the manual?
Explains how SDRuno runs in multiple instances, each with a different input device.
Describes the main window as the control centre of a SDRuno instance for managing various functions.
Details the Virtual Receiver (VRX) as a software-based receiver and its four component windows.
Guides users through building a simple test workspace by manipulating VRX windows.
Explains how to save, recall, and rename workspace memory positions.
Describes how to select the folder for saving recorded audio or IQ data.
Explains the use and interaction methods for slider controls in SDRuno.
Explains how to set asymmetrical selectivity filters using the CTRL key.
Describes how to tune the pass band of filters by adjusting both edges simultaneously.
Highlights new features in Synchronous AM (SAM), including AGC and PLL filter improvements.
Details how to enter and set a new frequency offset for external converters.
Explains how to enable a previously set converter frequency offset.
Describes how to disable any active converter frequency offset.
Covers activating inverted spectrum mode for converters with higher LO frequencies.
Details how to select or enter the serial communication device (COM port) for CAT.
Explains how to select the serial device's baud rate for CAT communication.
Covers the option to allow controlling programs to set the VRX RX mode.
Explains how to select the target Omnirig device (RIG1 or RIG2) for synchronization.
Covers synchronizing the VRX to the RIG, allowing the device to reflect VRX changes.
Explains synchronizing the RIG to the VRX, enabling features like TX muting.
Lists the prerequisites and files needed to use Tmate and Tmate 2 controllers with SDRuno.
Explains the Tmate server's role in enabling bi-directional communication for Tmate controllers.
Covers enabling/disabling the Tmate server and checking its running status.
Explains the AUTO ASSIGN option for automatically assigning Tmate controls to focused VRX windows.
Details Tmate 2 selection and its LCD backlighting options.
Describes the Tmate tuning knob's functionality, including step increments and speed-based multipliers.
Explains the functions of Tmate buttons F1 (Decrease Step), F2 (Increase Step), F3 (Knob Lock), and F4 (Mute).
Explains the functions of Tmate 2's Main, E1, and E2 encoders for tuning and filter adjustments.
Details Tmate 2 buttons F1-F6 for step changes, knob lock, assignable functions, RX mode, and VRX selection.
Introduces memory banks as collections of 'memory locations' for storing reception channel data.
Describes the memory bank file format as a common CSV text file with a .s1b extension.
Lists new GUI items like the Memory Panel and buttons for memory bank operations.
Explains how to reorder columns in the data grid by dragging column headers.
Details methods for manually editing cells, including using F2 or double-clicking.
Describes how to insert a new blank row into the data grid using the Ins key.
General| Receiver Type | Software Defined Radio |
|---|---|
| Operating System | Windows |
| Frequency Range | 1 kHz to 2 GHz |
| Sample Rate | Up to 10 MHz |
| Maximum Bandwidth | 10 MHz |
| ADC Resolution | 14-bit |
| Audio Output | Stereo |
| Interface | USB |
| Software | SDRuno |
| Tuning Resolution | 1 Hz |
| RF Input Connector | SMA |
| Power Supply | USB powered |
| Supported SDR Hardware | SDRplay RSP1, RSP2, RSPduo |
| Modulation Modes | AM, FM, SSB, CW, DRM |
