SDRPLAY SDRuno - Tmate 2 Controller Operations; Encoders (Main, E1, E2); Function Buttons (F1-F6)

R1.1 Copyright © 2016 SDRplay Limited 28
SDRuno User Manual
10.5.2 E1 ENCODER
The function of this control can be selected by the user: pushing the knob selects the current function
among the five available:
- VOL adjust the VRX audio level (AF level or volume).
- RFG adjust the AGC gain (if AGC is enabled) or the RF gain (if AGC is disabled).
- SQL adjust the squelch threshold.
- NR adjust the amount of Noise Reduction
- NB adjust the threshold of the Noise Blanker
10.5.3 E2 ENCODER
The function of this control can be selected by the user: pushing the knob selects the current function
among the two available:
- HIGH adjust the selectivity filter high frequency limit.
- LOW adjust the selectivity filter low frequency limit.
Pushbuttons:
10.5.4 F1 – DECREASE STEP
This button decreases the tuning step to the next lower value (if available).
10.5.5 F2 – INCREASE STEP
This button increases the tuning step to the next higher value (if available).
10.5.6 F3 – KNOB LOCK
This button locks/unlocks the tuning knob; the locking status is indicated in the RX Control window, to the
left of the frequency dial and by the LOCK LED on the Tmate 2 panel.
10.5.7 F4 – ASSIGNABLE BUTTON
The function of this button depends upon the current parameter controlled by the E1 encoder:
- VOL MUTE on/off.
- RFG AGC on/off.
- SQL squelch on/off.
- NR Noise Reduction on/off.
- NB Noise Blanker on/off (NBW only).
10.5.8 F5 – RX MODE
This button selects the current receiving mode.
10.5.9 F6 – VRX SELECTION
This button assigns the Tmate to the next VRX of the same instance.