8
Apply Locktite 246 to the stainless cap screws and slide
them through the tubular spacers. Alternately start to
tighten the cap screws with an Allen wrench but stop just
before the spacers start to touch the gold parts. Rotate
the lower ring and top cap to the orientation shown below
so you can get the Allen wrench on the cap screw. Just
before the cap screws are snug, squeeze the two
spacers together with your fingers so that they engage
the lower hex. Tighten the cap screws fully. You can
rotate the injector to orientate the connector as desired.
To Next Page
Loading...