Need help?Do you have a question about the SE Electronics sE2300 and is the answer not in the manual?
Controls signal reduction via a switch for loud instruments or close-miking.
Filters unwanted low frequencies like rumble or plosives at 80Hz or 160Hz.
Allows selection of omnidirectional, cardioid, or figure-eight polar patterns.
Instructions for cleaning the microphone with a soft cloth and storing it.
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Connector | XLR |
| Diaphragm Size | 1 inch |
| Low Cut Filter | 80 Hz |
| Power Requirements | 48V Phantom Power |
| Signal to Noise Ratio | 78 dB |
| Self Noise | 16dB (A-weighted) |
| Pads | -20 dB |
To Next Page
