Need help?Do you have a question about the SE Electronics X1 S and is the answer not in the manual?
General| Type | Studio microphone |
|---|---|
| Low-cut filter | 160 Hz |
| Attenuation pad | 20 dB |
| Voice coil type | Condenser |
| Sensitivity (1kHz) | 30 mV/Pa |
| Microphone frequency | 20 - 20000 Hz |
| Equivalent noise level | 9 dB |
| Microphone sensitivity | -30.5 dB |
| Microphone direction type | Cardioid |
| Microphone input impedance | 125 Ω |
| Recommended load impedance | 1000 Ω |
| Certification | IEC 61938 |
| Product color | Black |
| Operating voltage | 48 V |
| Power consumption | 6 mA |
| Device interface | XLR-3 |
| Connectivity technology | Wired |
| Number of products included | 1 pc(s) |
Weight and Dimensions| Height | 169 mm |
|---|---|
| Diameter | 58 mm |
| Microphone weight | 445 g |
Details the X1 S as a high-quality condenser microphone for studio applications, featuring a custom design and hand-crafted capsule for pristine sound.
Lists the items included in the packaging: X1 S microphone, microphone stand clip, and thread adapter.
Located on the front-left, this switch reduces the incoming signal by 10 or 20 dB to prevent distortion with loud sources or close-miking.
Located on the front-right, it inserts an 80Hz or 160Hz low-cut filter to reduce unwanted noise like wind or rumble, and minimize proximity effect.
Requires a 48-Volt phantom power source according to IEC 61938, using a floating connector and balanced cable.
Ensures connected equipment meets safety regulations and is fitted with a ground lead to prevent damage.
Clean the microphone with a dry, soft cloth after use and store it in a solid case or zipper pouch.
Contact your dealer for service or visit seelectronics.com for support and registration to extend warranty to three years.
Provides contact details for sE Electronics International, Inc., including address, website, and email.
To Next Page
