SE Electronics sE2300 - Page 4

4
Sensitivity
24 mV/Pa (-32.5 dBV)
Max. SPL (0.5% THD)
126 / 136 / 146 dB
SPL
(0/10/20 dB Attenuation pad)
Equivalent noise level
9 dB(A)
Dynamic range
117 / 127 / 137 dB (0/10/20 dB Attenuation pad)
Signal-to-noise ratio
85 dB
Low cut filter
80 / 160 Hz, 6 dB/Oct, switchable
Attenuation pad
10 / 20 dB, switchable
Powering
48 Volts according to IEC 61938
Electrical Impedance
40 Ohms
Recommended load impedance
>1k Ohms
Current consumption
4.8 mA
Connectivity
3-pin male XLR connector
Dimensions
Diameter: 51 mm (2.01 in.) Length 215 mm (8.46 in.)
Weight
611 g (21.55 oz.)
Omnidirectional
Cardioid