87
1. Rear electrical box
2. Remove vent tubes
All Models
TYPICAL
Unclip and remove cover of the electri-
cal box.
TYPICAL
1. Fuse holder
All Models
Properly reinstall removed components.
General Inspection and
Cleaning
Inspection
Check engine compartment for any dam-
age and fuel/oil injection systems for
leaks. Ensure all hose clamps are proper-
ly secured and no hose is cracked, kinked
or presenting any other damage.
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visually
check electrical connections for corro-
sion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have dam-
aged parts repaired.
Cleaning
The bilge should be cleaned by an au-
thorized Sea-Doo dealer to remove any
fuel/oil/electrolyte deposits and mil-
dew.
Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non-abrasive
wax such as silicone wax.
CAUTION: Never clean fiberglass and
plastic parts with strong detergent,
degreasing agent, paint thinner, ace-
tone, etc.
Stains may be removed from seat and
fiberglass with Knight’s Spray-Nine
from Korkay System Ltd or the equiv-
alent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.
F12H01Y
12
F07H07Z
F12H02Y
1
WARNING
If any gasoline leak and/or odor are
present, do not start the engine.
Have the watercraft serviced by an
authorized Sea-Doo dealer.
WARNING
Periodically verify the seat lock pin
and tighten if needed. Make sure
seat securely latches.
smo2001-003a.book Page 87 Wednesday, August 30, 2000 1:25 PM
To Next Page
Loading...
Need help?
General