Sea-doo Spark Series User Manual

106
LLHH AACCCCEESSSS CCOOVVEERR
1. To unlock, turn the knob 1/4 turn clockwise
Locate the expansion tank cap.
1. Expansion tank cap
With watercraft on a level surface, add
coolant until it is visible without ex-
ceeding the COLD level mark in cool-
ant reservoir when engine is cold.
1. Cold level mark
NNOOTTEE::
The watercraft is level when it is in
water. When on a trailer, raise trailer
tow pole and block in this position
when bumper rail is level.
Add coolant, see
Recommended En-
gine Coolant
for specification, to ad-
just coolant level between marks as
required. Use a funnel to avoid spill-
age. Do not overfill.
Properly reinstall and tighten expan-
sion tank cap, then reinstall the LH ac-
cess cover in the reverse of removal
procedure and lock the knob by turn-
ing it 1/4 turn counterclockwise.
MAINTENANCE PROCEDURES

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)