Sea Eagle 9 - REPAIRS; Repair Kit Usage; Pinholes and Small Punctures; Patching Technique

13
Repair Kit
All Sea Eagles come
standard with a repair kit
that includes patching
material and tubes of PVC
glue.
Motormount Boat SE9 | REPAIRS
Even though Sea Eagles are very rugged and tough, you may
still experience the occasional puncture. Fortunately most
repairs are fairly easy and only take a few minutes. For
extensive repairs, please contact us directly to provide you
with further assistance. The best way to do this is to e-mail us a
digital photo of the area in question along with your hull
identification number to staff@seaeagle.com.
You can also call us directly at 1-800-748-8066 ex. 314 and
ask to speak with Technical Support for further assistance or a
quote for having your boat mailed to our facilities for our
professional repair services.
Sea Eagle repair fees start at $75.00 and does not include
return shipping charges. Please note that Sea Eagle does not
service any other brand other than our own. All items sent to
our repair facilities must have prior authorization in the form of
a Return Authorization Number.
To patch your Sea Eagle,
use an adhesive for PVC
boats.
Plumber’s cement, epoxy,
Flex Seal, water-poofing
sprays and Gorilla Glue do
not work.
Pinholes
Deflate the boat and
thoroughly clean and dry
the area that is to be
repaired.
For small punctures less
than 1/8” apply a small
drop of glue and allow 24
hours to cure.
Patching
The most common
repairs are a puncture or
small cut. A penny size
patch is sufficient for
repairs of this type.
Note: A small paint brush
(not included) can come in
handy for spreading glue.
Trace the outline of a
penny on the patch
material and on the boat.
If a larger patch is needed,
use a larger item as a
template.
Cut patch along the outline
with scissors.
Pro Tip: Trace the outline
of the penny on masking
tape and cut with a utility
knife. Apply tape to the
boat instead of tracing on
the boat.
Apply glue to the patch
and boat. Allow to dry 15
minutes. Glue must be dry
to the touch. If glue layer
is thin, apply second coat,
allow to dry 15 minutes.