14
DO NOT USE GLUE ON
ACCESSORIES
The SE9 is manufactured
with a type of (stretchable)
PVC material that cannot
accommodate the use or
application of gluing on
D-Rings, Scotty™ Glue On
Mounts or other glue on
accessories that can cause
stress and damage the boat.
Motormount Boat SE9 | REPAIRS
Apply patch to the boat.
Smooth with finger or a
smoothing tool such as a
spoon, handle of a utility
knife, or screwdriver. For
best results, heat patch
with a hair dryer 10-20
seconds and smooth with
tool.
Patching Tips:
• The chamber must be deflated or the air will force a path
through the glue.
• Keep the patch size to a minimum, the bigger the patch,
the harder it is to seal. The most common repair failures
occur because the patch is too big.
• For repairs larger than a puncture, overlap the damage area
by about ½” on each side.
• Do not apply the patch while the glue is wet.
• Covering a leaking patch with another patch rarely fixes
the problem. To remove a patch, heat it with a hair dryer and
peel it off.
• For field repairs, allow at least an hour to cure. Other
repairs, allow to cure overnight.
• Patches can be removed by heating with a hairdryer.
• Never use a heat gun on your boat.
• Clamps and weights are not needed.
For a demonstration of good patching technique, please view
the How to Repair video on the instruction page of our web
site. There is a link at the bottom of every page at
SeaEagle.com or type “instructions” into the search box.
To Next Page
Loading...
