SEABOB F5 - Page 12

1
| Page 12 | SEABOB Operator's Manual |
circuit while the SEABOB is being charged or even before this process has begun.
If a short circuit occurs, it can cause irreparable damage to the charging contacts
of the SEABOB. Short circuits can cause fires.
• Always ensure that the Trigger is functioning properly. When you release the
Trigger, the SEABOB should immediately switch off. The Trigger should be able to
move freely in all positions. When released, it should always return unobstructed
to the OFF position. A damaged or sticking Trigger should be repaired or replaced
immediately. If the Trigger is not functioning properly, you can stop the motor by
tapping the red button repeatedly until the power is displayed as "0 %".
• Never run the motor out of the water for longer than approx.
10 seconds. The seals of the motor and the hard-coated motor shaft are designed
exclusively for use in the water. Operation out of the water can cause overheat-
ing due to the lack of water to cool the device, thereby causing irreparable dam-
age to the seals and motor shaft. Danger of short circuit!
• The securing device below the display is used exclusively for the attachment of
the optionally available pilot belt system. It is not suitable for lifting the SEABOB.
Under no circumstances should the securing device be used to lift the SEABOB
using a crane or any other lifting device. The securing device could be pulled out
of the SEABOB housing during lifting. In this case, the SEABOB could fall and be
damaged or cause damage to other objects or injury or death to persons nearby.
• Lifting the SEABOB with a crane or lifting device may cause
injury or death to persons nearby should the craft fall from the device.
• Use the securing device only for the pilot belt system developed by CAYAGO
AMERICAS INC. Under no circumstances should any other objects or fixtures,
such as ropes or belts, be attached to the securing device. Risk of injury!
• Never open the SEABOB on your own. Repairs and mainte-
nance work on the SEABOB that go beyond the procedures described in Chapter 6
"Care" and Chapter 7 "Troubleshooting" may only be carried out by an authorized
technician since this action could result in severe injury or cause damage to the
SEABOB and will void your warranty.
• Never alter or modify any part of the SEABOB or Charger. Do-
ing so may result in serious injury or death and will void your warranty.
• If you detect any damage to the SEABOB, in particular to the
connection port and screw cap, immediately stop operating the device and re-
move the vehicle from the water to prevent further damage. Contact the manu-
facturer or your specialized dealer without delay.