Sealey RS131.V3 - User Manual

INSTRUCTIONS FOR
ROADSTART EMERGENCY POWER PACKS
MODEL NO’S: RS131.V3, RS132
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on
engines.
1.1. PERSONAL PRECAUTIONS
 Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working
near a lead-acid battery.
 Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
 Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
 Washimmediatelywithsoapandwaterifbatteryacidcontactsskinorclothing.Ifacidenterseye,usheyeimmediatelywithcool, 
clean running water for at least 15 minutes and seek immediate medical attention.
 Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
current high enough to weld a ring or the like to metal, which may cause severe burns.
1.2. IMPORTANT SAFETY INSTRUCTIONS
 Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.
 Keep the unit in good working order and condition. Replace damaged parts immediately.
 Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.
 TheRoadStartmustonlybeopenedandcheckedbyqualiedservicepersonnel.DO NOT disassemble the unit for any reason.
 Keep children and unauthorised persons away from the work area.
 Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.
 IftheRoadStartreceivesasharpknockorblow,itmustbecheckedbyaqualiedserviceagentbeforebeingused.
 When not in use re-charge every two months.
 DO NOTsmokeorallowaspark,orameinthevicinityofthebatteryorengine.
 DO NOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.
 DO NOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode and
cause personal injury and damage to property.
 DO NOT charge or boost a frozen battery.
 DO NOT use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible
personal injury.
 DO NOT pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.
 DO NOToperateinvicinityofammableliquidsorgases.
 DO NOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.
 DO NOT use this product to perform a task for which it is not designed.
 DO NOT store the unit in damp or wet locations or where the temperature may exceed 50°C.
 DO NOT submerge the unit in water.
Refer to
Instruction
Manual
Warning:
Explosive
Material
Warning:
Corrosive
substance
Wear eye
Protection
RS131.V3 RS132 | Issue 5(I) 04/01/16
Original Language Version
© Jack Sealey Limited
IMPORTANT WARRANTY INFORMATION: KEEP YOUR ROADSTART HEALTHY
Read and understand the general safety and operating instructions before use. The following information is intended to help you
keep the product in top working order.
NOTE – The battery in this unit is a consumable item and its ability to accept charge will reduce over time. We will warranty it
against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will
not replace the battery even if it is less than one year old.
You can help prolong the lifecycle of the battery by following a few simple guidelines.
• Plug in your new Roadstart to the mains transformer and make an INITIAL charge lasting 38 hours.
• Ensure the unit is fully charged before storage.
• DO NOT leave the Roadstart for longer than 2 months without putting it on charge.
• DO NOT attempt to start a vehicle when the Roadstart battery voltage is reduced to less than 7Volts.
• DO NOT drop or roughly handle the Roadstart – this will break or disjoin the battery terminals rendering the battery useless and the
warranty void.
• DO NOT use any other charger, other than the one supplied, to recharge the battery.
Wear
Protective
Gloves
Warning:
Electricity
Protect
From
Rain
Use in
Well
Ventilated
Areas
Keep away
from sources
of ignition:
Battery could
explode

Summary

Safety and Warranty Information

General Safety Precautions

Covers personal safety measures and essential operational safety guidelines for using the RoadStart unit.

Warranty Guidelines

Details on keeping the RoadStart healthy and prolonging battery lifecycle, including initial charging.

Electrical Safety, Introduction, and Specification

Electrical Safety Regulations

Covers responsibilities regarding electrical safety, including testing and user obligations.

Product Overview

Describes the composite case, LED indicators, and integrated features of the RoadStart unit.

Technical Specifications

Lists key technical data for RS131.V3 and RS132 models, including amps, voltage, and weight.

Product Features

Component Identification

Identifies and lists all numbered parts and features of the RoadStart units as per figures.

Charging Instructions

Initial Charging Procedure

Details the essential first-time charging process for the RoadStart unit, including duration.

Reading LED Power Indicators

Explains how to interpret the LED lights for battery status and charge level.

Recharging Methods

Instructions for recharging using the AC adaptor and the DC charging cable.

Operation Modes

Preparation and Precautions

Essential pre-operation checks, including voltage matching and clamp connection safety.

Vehicle Battery Boosting

Procedure for charging the vehicle battery using the RoadStart unit via the cigarette lighter socket.

Emergency Jump Starting

Step-by-step guide for jump starting a vehicle, including connection and disconnection procedures.

Additional Operational Uses

Alternative Power Supply

Using the unit to maintain vehicle memory systems when the battery is disconnected.

Multipurpose Power Output

Using the 12V DC socket to power various accessories up to 17 amps.

Worklight Functionality

Instructions for using and replacing the integrated Krypton worklight bulb.

Using the Compressor

Inflating Tyres

Guide on using the compressor to inflate vehicle tyres and checking pressure.

Inflating Inflatable Items

Instructions for inflating items like air beds or rubber rafts using the compressor.

Maintenance and Disposal

Storage Recommendations

Guidance on storing the unit at room temperature and periodic recharging.

Battery Removal and Disposal

Steps for safely removing and disposing of the sealed lead-acid battery.

Troubleshooting

Common Issues and Solutions

Addresses problems like unit not charging, no power output, and provides solutions.

Environmental and Warranty Details

Environmental Protection and WEEE

Information on recycling and disposing of the product according to environmental regulations.

Warranty and Policy Information

Details on the 12-month warranty, producer registration, and policy for product improvements.

Sealey RS131.V3 Specifications

General

USB Output	5V/2.1A
Battery Type	Lead Acid
Charging Input	230V
Features	LED worklight
AC Output	Not available