• 11 •
Smart Cable LED and Alarm Behavior
BEHAVIOUR REASON
Green LED blinking; Red
LED o; no beep.
Cable is connected to battery only.
Cable is connected to jump starter
only.
Green LED solid; Red
LED o; no beep.
Cable is connected correctly to
both battery and jump starter.
Solid Red LED, Green
LED o; beeps once per
second.
Low voltage protection.
Solid Red LED, Green
LED o; beeps twice per
second.
Reverse polarity protection.
Alternating Red and
Green ashing LEDs; no
beep.
Reverse charging protection.
Solid Red LED, Green
LED o; rapid beeping.
Short circuit protection.
Solid Red and Green
LEDs; no beep.
Auto shut-o, due to inactivity.
Disconnect and reconnect clamps
to the vehicle battery.
Solid Red and Green
LEDs; beeps once per
second.
Temperature protection.
NOTE: When the condition is corrected, the smart cable will
automatically reset.
11. SPECIFICATIONS
Auxiliary output: .............................................................
USB (x2) - 5V/2.4A, 5V/Quickcharge 3.0
Cable & clamp length: ........................................ 440mm
Capacity: ......................... 10Ah @ 3.2V, 2.5Ah@ 12.8V
Max. current: ..........................................................800A
Max. starting capacity: ......................4L petrol/2L diesel
Size (W x D x H): ............................... 84 x 34 x 173mm
Voltage: ................................................................... 12V
To Next Page
Loading...
