Sealey SL67S - Maintenance Instructions; Storage Instructions

• 9 •
charging cable from the unit. Slide the ON/OFF switch to
the OFF position.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB
ports will automatically shut o󰀨 after 30 seconds.
7.3 USING THE LED LIGHT
1. Slide the ON/OFF switch to the ON position.
2. Hold down the display button for 3 seconds.
3. Once the LED light is on, press and release the display
button to cycle through the following modes:
• Steady glow
• Flash for an SOS signal
• Flash in strobe mode
4. When nished using the LED light, press and hold the
display button until the light turns o󰀨.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
8. MAINTENANCE INSTRUCTIONS
1. After use and before performing maintenance, unplug
and disconnect the unit.
2. Use a dry cloth to wipe all battery corrosion and other dirt
or oil from the battery clamps, cords, and the outer case.
3. Do not open the unit, as there are no user-serviceable
parts.
9. STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between
-
4°F-
+
140°F
(
-
20°C-
+
60°C).
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every month, if not in frequent use,
to prevent over-discharge.