RESET OK!
Press any key to con.
Setting Inspection Interval
The Set Insp. Interval function is used to set oil service interval of
different channels.
1) Use UP/DOWN scroll button to select Set Insp. Interval, and
press Y button.
2) Wait a few seconds till the following screen shows.
3) If the oil service reset is not automatically performed by the scan
tool, the following screen appears. You need to perform manual
setup.
Oil Service
RESET OK!
Oil Service
1) Auto Detect
►2) Longlife Oil
3) Non Longlife Oil
4) Set Insp. Interval
Press any key to con.
To Next Page
Loading...