seapro Standard Model - Miyota VD54;VD53 Movement Instructions

To Next Page

To Previous Page

Chronograph Stopwatch

CAL. VD54 (with date - VD53)

(1 crown/2 pushers)

Time Setting

1. Pull crown out to position 2.

2. Set the time by turning the crown.

3. Push the crown back to position 1.

24-Hour Sub-Dial Setting

The 24-hour hand moves correspondingly with the hour and minute hands. When setting the time be sure to check that the 24-hour hand is

set properly.

Using the Stopwatch

Check the stopwatch minute and second hands to see if they are in the \ 230” position. If not, follow the stopwatch hand adjustment instructions.

Pressing A stops and starts the stopwatch. Pressing B controls the split time and resets.

Stopwatch Hand Adjustment

1. Pull crown out to the position 2.

2. Press A or B at the same time to reset the stopwatch minute and second hands to the “0” position.

3. With each press of A or B (A= forward, B= back), the hands move once clockwise or counter-clockwise. The hands move quickly if the

pushers are kept pressed.

NOTE: If the stopwatch hands move improperly, pull crown out and press A and B at the same time for over 2 seconds. When the pushers

are released, the stop-watch second hand will turn counter-clockwise and return to original position.

4. Push crown back to position 1.

24-HOUR HAND

MINUTE HAND

SECOND HAND