seapro Standard Model - Page 21

Chronograph Model C (Cal 5040 D)
Setting the timers to zero:
Corrective mode must be started to set the timers back to zero.
While in corrective mode the timers must be reset in
sequential order as described below.
Corrective mode:
1. Pull crown to position 3.
2. Press pusher A and B simultaneously for 2 seconds.
(Second hand rotates 360 degrees and corrective mode
is activated.)
To reset the 60 second timer:
1. Press pusher A until the timer is at zero.
2. Press pusher B.
3. If the other timers need to be reset then proceed, otherwise push crown back to position 1.
To reset the 1/10 second timer:
1. Press pusher A until the timer is at zero.
2. Press pusher B.
3. If the 30 minute timer needs to be reset then proceed, otherwise push crown back to position 1.
To reset the 30 minute timer:
1. Press pusher A until the timer is at zero.
2. Push crown back to position 1.
Second hand
30 minute
timer
1/5
second timer
1/10
second timer
A
B
Date
window
1 3
2
17