I English I
USES FOR YOUR:
S_ AlfltS/ CR F'FSH R °
3 Pre-set Temperatures:
Heat Gun 120°F./800°F../.lOOO°F.
Forming and shaping plastic,
plastic materiaNs
® Soften PVC pipe and other
plastic materials for bending and
shaping
® Soften vinyl floor coverings and
around mouldings
@Soften formica coverings
for shaping on rounded edges
Soldering
@Soldering copper pipe up to
3/4". Can use90/10 solder
@Activate solder and wire connectors
Drying
• Quick drying of automotive body
fillers
® Drying paint samples
@Drying plaster filling compounds
Thawing
®Thaw frozen water pipes
• Thaw frozen locks
Shrinking
@Shrinking shrink tube insulators
@Heat shrink PVCtubes
® Heatshrink packaging wrap
Roofing
® Heating Modified Bitumen
®Welding Single Ply Material
Removalof adhesives
@Activating Heat sensitive adhesives
® Removalof pressure sensitive,
stickers
@Removalof flooring adhesives
Other Uses
@Fiberglasswork
®Wax removalon skies and
surfboards
@Apply hot patches
® Paintstripping
Q Softening hardened window
glazing
O Plasticwelding
I
I CAUTION: It is recommended that the user experiment
I
on scrap materials before using for a specific task.
Page 8
ACCESSORIES
r THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENTAND --7
WERE AVAMLABLEAT THE TIME THiS MANUAL WAS PRINTED. !
/
9-11802; 3' inch Surface Nozzle
Provides an even distribution of hot air
over a large surface.
9-11803; 3" inch Window Nozzle
Designed with deflector to direct hot air away
from glass and other delicate surfaces to
prevent overheating.
9-11804; 1 3/16" inch Reflector Nozzle
Reflects hot air flow around surfaces of
small-diameter, heat-sensitive materials
for smooth, even heating.
9-11809; 3" inch Reflector Nozzle
Reflects hot air flow around surfaces of
large-diameter, heat-sensitive materials
for smooth, even heating.
9-11806; 3/4" inch Reduction Nozzle
Concentrates hot air flow and pinpoints it
onto a limited area.
CAUTION: This Heat Gun (9-11801)
not for use with 5/16-in, reduction nozzle, slit welding
nozzle or polystyrene foam cutting accessory (all sold
separately).
Use with these accessories will damage Heat Gun.
Page 9
To Next Page
Loading...
