Cylinder Alignment Valve
11
BLEEDING THE SYSTEM
Non-Power Purge Users
All Applications
Refer to the plumbing diagrams in the left hand column and locate
YOUR plumbing details and bleeder nipple sequence. You will NOT
remove ALL the air if the sequence is NOT followed properly.
NOTICE
1. Fill helm with oil and attach filler device/container to helm.
2. OPEN valve.
3. OPEN bleed fitting 1 and pull cylinder shaft all the way out on
fitting 1 side of cylinder.
4. Turn steering wheel clockwise until an air free stream of oil
comes forth from bleed fitting 1. CLOSE bleeder 1.
5. OPEN bleed fitting 2 and pull cylinder shaft all the way out on
fitting 2 side of cylinder.
6. Turn steering wheel counter-clockwise until an air free stream of
oil comes forth from bleed fitting 2. CLOSE bleed fitting 2.
7. OPEN bleed fitting 3 and pull cylinder shaft all the way out on
fitting 3 side of cylinder.
– INBOARD/STERNDRIVE. Turn steering wheel clockwise until
an air free stream of oil exits bleeder fitting 3. CLOSE bleeder
fitting 3.
– OUTBOARD/HC5332. Turn steering wheel counter-clockwise
until an air free stream of oil exits bleeder fitting 3. CLOSE
bleeder fitting 3.
8. OPEN bleed fitting 4 and pull cylinder shaft all the way out on
fitting 4 side of cylinder.
– INBOARD/STERNDRIVE. Turn steering wheel clockwise until
an air free stream of oil exits bleeder fitting 4. CLOSE bleeder
fitting 4.
– OUTBOARD/HC5332. Turn steering wheel counter-clockwise
until an air free stream of oil exits bleeder fitting 4. CLOSE
bleeder fitting 4.
9. CLOSE alignment valve.
10. Go to page 13 of this manual for realignment procedures.
11. Conduct Oil Level and System Check as directed on page 13.
INSTALLATION INSTRUCTIONS
STARBOARDPORT
2
134
HELM
STARBOARD
PORT
1
234
HELM
PORT
2
143
HELM
STARBOARD
Figure 13. Stern Drive and Inboard.
Figure 14. Front Mount Cylinder and
HC5332 Sterndrive Cylinder.
Figure 15. Side/Splashwell Mount cylinders.
To Next Page
Loading...
Need help?
General