Seat ateca - Page 110

Emergencies
Turn signal bulb
R
ai
se the bonnet
.
Move the loop ››› Fig. 107
1
in the di-
r
ection of
the arr
ow and remove the cov-
er.
Turn the bulb holder ››› Fig. 108
3
anti-
c
loc
k
wise and pull.
Remove the bulb by pressing on the
bulb holder and turning it anticlockwise
at the same time.
Installation involves all of the above
steps in reverse sequence.
1.
2.
3.
4.
5.
Front fog light bulb*
Fig. 109 Fog light: extracting the grille.
Fig. 110 Fog light: remove the bulb holder
Follow the steps indicated:
R
emo
v
e the screw ››› Fig. 109
1
 fr
om
the f
og light
grille using a screwdriver
and extract the grille.
Remove the 3 screws ››› Fig. 109
2
.
R
emo
v
e the metal clip situated on the
upper part of the fog light by pulling
away from the vehicle
3
 and e
xtract
the f
og light
.
Remove connector
›››
Fig. 110
1
from
the b
u
l
b.
Turn the bulb holder
›››
Fig. 110
2
anti-
c
loc
k
wise and pull.
Remove the bulb by pressing on the
bulb holder and turning it anticlockwise
at the same time.
Installation involves all of the above
steps in reverse sequence.
Check that the bulb works properly.
1.
2.
3.
4.
5.
6.
7.
8.
108