Driver assistance systems
obstacles on the road. This could cause an
accident and serious injuries. If necessary,
apply the brake.
CAUTION
If you increase speed using the accelerator
pedal, the ACC may not be able to safely
adjust the speed of the distance due to the
limitations of the system.
●
Be prepared to react if required by the
situation.
Status display
Fig. 180
On the instrument panel display:
ACC active.
Vehicle ahead detected. It will light up if
the distance to the vehicle is adjusted.
Selected distance level 2.
This information can be displayed on the
central panel of the Assists view, or in the left
hand information profile
›››
page 68. If these
views are not selected, it will be automatical-
ly displayed in the lower central part of the
instrument cluster in a simplified manner.
The set speed will be displayed next to the
function status indicator described in
›››
page 249, Start regulation.
Special driving situations
Fig. 181
On the instrument panel display: ACC
active, vehicle detected in an outer lane.
1
2
Be aware of the limitations and warnings de-
scribed at the beginning of this chapter.
›››
in Introduction on page 249.
Avoid undertaking on the right
1)
If a vehicle is detected in the left lane that is
travelling at a speed slower than that set by
the driver, it will brake the vehicle within the
comfort limits of the system to avoid passing
it on the right
›››
Fig. 181.
You can cancel this regulation by changing
the set speed or by pressing the accelerator
pedal.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
Overtaking
When the turn signal is switched on for over-
taking, the ACC reduces the distance from
the vehicle in front to help with the overtaking
manoeuvre. The set cruising speed will not be
exceeded.
The function works at speeds over 80 km/h
(50 mph). It may not be available in certain
countries.
»
1)
Or on the left, in countries that drive on the left
hand side of the road.
251
To Next Page
Loading...
