Emergencies
Integral wheel trim
Fig. 40
Remove the wheel cover.
The wheel covers must be removed for ac-
cess to the wheel nuts.
Removing
●
Take the wheel brace and the wire hook
from the vehicle tool kit
›››
page 44.
●
Hook the wire through one of the grooves of
the trim.
●
Insert the box spanner through the hook,
rest it on the tyre and remove the wheel trim
›››
Fig. 40.
Fitting
●
Press the trim against the wheel so that the
hole for the valve fits over the tyre valve.
●
Make sure that the trim is correctly fitted all
the way around the wheel. If you are using an
anti-theft wheel lock, screw it in the opposite
position to the valve.
Wheel bolt caps*
Fig. 41
Wheel: wheel nuts with caps.
Removal
●
Fit the plastic clip (vehicle tools
›››
Fig. 38)
over the cap until it clicks into place
›››
Fig. 41.
●
Remove the cap with the plastic clip.
The caps protect the wheel nuts and should
be remounted after changing the tyre.
The anti-theft wheel locking bolt has a
special cap. This only fits on anti-theft locking
bolts and is not for use with standard wheel
nuts.
Anti-theft wheel nuts*
Fig. 42
Anti-theft wheel bolt with cap and
adapter.
Loosening the anti-theft wheel bolt
●
Remove the wheel cover* or the cap*.
●
Insert the special adapter
›››
Fig. 42
1
(ve-
hicle tools
›››
page 44) onto the anti-theft
wheel bolt and push it on as far as it will go.
●
Insert the wheel brace (vehicle tools) onto
the adapter as far as it will go.
●
Remove the wheel bolt
›››
page 49.
Note
Make a note of the code number of the an-
ti-theft wheel bolt and keep it in a safe
place, but not in your vehicle. If you need a
new adapter, you can obtain it from the
SEAT Official Service, indicating the code
number.
48
To Next Page
