Emergencies
deactivated. If the vehicle has no power
supply or there is an electric system fault,
the engine must be tow-started
›››
page 53
to deactivate the electronic parking brake
and the electronic lock of the steering col-
umn.
Front towline anchorage
Fig. 51
On the right side of the front bumper:
remove the cover.
Fig. 52
Right side of the front bumper: towline
anchorage in position.
The housing of the removable towline an-
chorage is on the right side of the front bump-
er underneath a cover
›››
Fig. 51.
The towing eye should always be kept in the
vehicle.
Bear in mind the instructions for towing
›››
page 56.
Fitting the towline anchorage
●
Remove the towing eye from the vehicle
tool kit in the luggage compartment
›››
page 44.
●
Remove the cover by pressing down on its
base and leave it hanging from the vehicle
›››
Fig. 51.
●
Screw the towing eye in the housing by
turning it as far as it will go anticlock-
wise
›››
Fig. 52
›››
. Use a suitable object
that can completely and securely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye
clockwise with a suitable object.
●
Replace the cover and tighten on its right
side until the tab snaps into the bumper.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along
with the other vehicle tools.
CAUTION
The towing eye must always be completely
and firmly tightened. Otherwise, it could be
released while towing and tow-starting.
58
To Next Page
Loading...
