Opening and closing
To change the battery
Fig. 83
Vehicle key: opening the battery com-
partment cover.
Fig. 84
Vehicle key: removing the battery.
SEAT recommends you ask a specialised
workshop to replace the battery.
The battery is located to the rear of the vehi-
cle key, under a cover.
Changing the battery
●
Remove the key blade from the vehicle key
›››
page 96.
●
Insert the key blade into the slot
›››
Fig. 83,
press it in the direction of arrow
1
and de-
tach the cover by levering it
2
.
●
Extract the battery from the compartment
using a suitable thin object
›››
Fig. 84.
●
Insert the new battery and press it into the
battery compartment
›››
.
●
Place the cover and press it into the vehicle
key housing until it clicks into place.
WARNING
Swallowing a battery with a 20 mm diame-
ter or any other button battery can cause
serious and even fatal injuries within a very
short time.
●
Keep the vehicle key and key fobs with
batteries out of reach of children.
●
If you suspect that someone may have
swallowed a battery, seek immediate med-
ical attention.
CAUTION
●
If the battery is not changed correctly,
the vehicle key may be damaged.
●
Use of unsuitable batteries may damage
the vehicle key. For this reason, always re-
place the dead battery with another of the
same voltage, size and specifications.
●
When fitting the battery, check that the
polarity is correct.
For the sake of the environment
Please dispose of your used batteries cor-
rectly and with respect for the environ-
ment.
Synchronize the vehicle key
If the
button is pressed frequently outside
of the vehicle range, it is possible that the ve-
hicle can no longer be locked or unlocked us-
ing the key. In this case, the key must be re-
synchronised as described below:
●
Remove the key blade from the vehicle key
›››
page 95.
●
Press the
button on the vehicle key. For
this, it must remain with the vehicle.
●
Open the vehicle within one minute using
the key blade. The key has been synchron-
ised.
●
If necessary, fit the cap.
97
To Next Page
Loading...
