Start and driving
Additional information related to the auto-
matic gearbo
x
The engine st
ops when the sel
ector lever is in
the positions P, D, N and S in addition to when
in Tiptronic mode. With the selector lever in P,
the engine will also remain switched off when
you take your foot off the brake pedal. In or-
der to start the engine up again the accelera-
tor must be pressed, or another gear engag-
ed or the brake released.
If the selector lever is placed in R while stop-
ped, the engine will start up again.
Change from D to P to prevent the engine
from accidentally starting when passing
through R.
Additional information about vehicles with
Adaptive Cruise Control (ACC)
In vehicles with ACC function, the engine will
start up again in certain operating conditions
if the radar sensor detects that the vehicle
ahead drives off again.
WARNING
●
Never s
witch the engine off until the vehi-
cle is stationary. The operation of the brake
and steering will not be fully guaranteed.
More force will be needed to turn the steer-
ing wheel or to brake. You could suffer an
accident and even serious injuries.
●
To avoid injury, mak
e sure that the Start-
Stop system is switched off when working
in the engine compartment
›››
page 205.
CAUTION
The Start-Stop system must always be
s
witched off when driving thr
ough flooded
areas
›››
page 218.
Note
●
In vehicles with an aut
omatic gearbox,
you can control whether the engine should
switch off or not by reducing or increasing
the brake force applied. While the vehicle
remains stopped, the engine will not stop if
the brake pedal is slightly pressed, in traffic
jams with frequent stopping and starting
for example. As soon as strong pressure is
applied to the brake pedal, the engine will
stop.
●
When stopped, the brake pedal must be
kept pressed to ensure that the vehicle
does not move.
●
If the engine “stalls” with a manual gear-
box, it can be directly started up again by
immediately pressing the clutch pedal.
●
With an automatic gearbox, if the lever is
placed in position D, N or S after engaging
reverse gear, 10 km/h (6 mph) in a forwards
direction must be reached for the system to
be in a status to stop the engine.
Manually connecting and discon-
necting the St
ar
t
-Stop system
Fig. 149
On the Infotainment system screen.:
St
art
-St
op system connected. View in the
main menu. View with the Infotainment sys-
tem off.
If you do not want to use the system, you can
disconnect it manually thr
ough the Inf
ot
ain-
ment system:
●
Select > Driver assistance.
When the symbol appears orange
›››
Fig. 149 the system is activated and will
stop and start. When the symbol appears
in white the system is disconnected.
»
205
To Next Page
Loading...
