Driving
departure warning's functions may be limi-
ted or work incorr
ectly if other paints are
used.
Note
If the lane departure warning with rear
cr
oss traffic al
ert does not work as descri-
bed in this chapter, stop using it and con-
tact a specialised workshop.
Control lamp
Fig. 174 Control lamp of the lane departure
w
arning.
Fig. 175 Control lamp of the lane departure
warning.
It lights up
It turns on once briefly: the lane departure warning is
activated and r
eady to operate, i.e. when activating
the system.
It lights up continuously: the lane departure warning
has detected a v
ehicle in the blind spot.
Flashes
A vehicle has been detected in the adjacent lane and
the turn signal has been engaged in the direction of
the det
ected vehicle
›››
.
For vehicles that are also equipped with Lane Assist
›››
page 239, a warning to switch lanes will also ap-
pear even though the turn signal has not been en-
gaged (lane departure warning “Plus”
›››
page 247).
The control lamps light up when the ignition is
s
wit
ched on and shoul
d turn off after approxi-
mately 2 seconds. This is the time taken for
the function check.
If there are no indications from the control
lamp of the lane departure warning, this
means that the lane departure warning has
not detected any other vehicles at the rear
area
›››
.
When the e
xt
erior lighting is l
ow, the intensity
with which the control lamps come on is dim-
med. The user can modify the intensity of the
control lamps with up to 5 levels in the info-
tainment system menu.
WARNING
If the warning lamps and the corresponding
messages are ignored when they light up
,
the vehicle may stall in traffic and cause
accidents and severe injuries.
●
Never ignore the warning lamps or mes-
sages.
●
Carry out the necessary operations.
CAUTION
Failure to heed the control lamps and cor-
responding te
xt messages when they light
up may result in damage to the vehicle.
246
To Next Page
Loading...
