Operation
●
Regularly cl
ean the area of vision of the
camera and keep it in a clean state, without
snow or ice.
●
Do not cover the field of vision of the
camera.
●
Always replace damaged or worn blades
when required to avoid lines on the cam-
era's field of vision.
●
Check that the windscreen is not dam-
aged in the area of the camera's field of vi-
sion.
●
The use of outdated maps on the naviga-
tion system may cause the system to show
traffic signs incorrectly.
●
In the waypoints mode of the navigation
system, the traffic sign detection system is
only partly available.
●
Failure to heed the control lamps and
corresponding text messages when they
light up may result in damage to the vehi-
cle.
Time
Setting the time on the infotainment sys-
t
em
●
Pr
ess
/ > Settings.
●
Select the menu option Time and date to
set the time
›››
page 83.
Setting the time on an analogue instru-
ment panel
●
In the classic view
›››
page 65 hold the but-
ton of the multifunction steering wheel
pressed when you have selected the date,
route and autonomy information.
●
Press and turn the button to make the
adjustments.
Setting the time on analogue the instru-
ment panel
●
When in the Trip data menu select the
Autonomy function ( > Interior > Instru-
ment panel).
●
Press the button on the multifunction
steering wheel until the Service menu is dis-
played on the instrument panel display
›››
page 67.
●
Select the menu Time.
●
Adjust the correct time by turning the right
thumbwheel of the multifunction steering
wheel.
Revolution counter
The rev counter indicates the number of en-
gine r
e
v
olutions per minute.
Together with the gear-change indicator, the
rev counter offers you the possibility of using
the engine of your vehicle at a suitable
speed.
The beginning of the red zone of the rev
counter indicates the maximum speed in any
gear after running-in and with the engine hot.
However, it is advisable to change up a gear
or move the selector lever to D (or lift your
foot off the accelerator) before the needle
reaches the red zone
›››
.
W
e r
ecommend that you av
oid high revs and
that you follow the recommendations on the
gear-change indicator. Consult the addition-
al information in
›››
page 213, Selecting the
optimal gear.
CAUTION
●
To pre
vent damage to the engine, the rev
counter needle should only remain in the
red zone for a short period of time.
●
When the engine is cold, avoid high revs
and heavy acceleration and do not make
the engine work hard.
For the sake of the environment
Changing up a gear early will help you to
save fuel and minimise emissions and en-
gine noise.
74
To Next Page
Loading...
