14
Mother-and-baby function (seca 881 only)
The mother-and-baby function enables the body weight of babies and small children to
be determined. The child is held in the arms of an adult. Proceed as follows.
– Switch on the scale.
– Wait until the display
0.00 appears.
– Stand on the scale without the child.
You can read off the weighing result on
the digital display.
– Now press the mother-and-baby key to
activate the function.
The scale stores the weight of the adult
and the display returns to zero.
0.00 and
the display TARE appear in the display.
– Now take the child onto the scale. You
can leave the scale to do this, in which
case
---- appears in the display.
The scale determines the weight of the
child. Once the value is stable for about 3
seconds, the display is retained. This
avoids the display jumping about as a re-
sult of the child’s movements.
HOLD and an arrow pointing to the
mother-and-baby symbol also appear in
the display.
If several children are to be weighed consecutively, it is important that it is al-
ways the same adult who performs the measurement and that this person’s
weight does not change (e.g. due to a piece of clothing being removed).
The mother-and-baby function remains switched on until
– you press the mother-and-baby key again (total weight is displayed).
– the scale switches off automatically.
5. Cleaning
Clean the outside of the scale as required using a domestic cleaning agent or a commer-
cially-available disinfectant. Follow the manufacturer’s instructions.
TARE
HOLD
TARE
Visit www.Balances.com Your Authorized Seca Dealer
To Next Page
Loading...
