Model 880/881 15
GB
6. What do I do if ...
... no weight is displayed when there is a load on the scale?
– Is the scale switched on?
– Check the batteries.
... the scale keeps switching on, while being transported, for example?
– The vibration switch has been activated by the movement of the scale. Due to the very
low energy requirement of the scale, the service life of the batteries will not be impaired.
For longer journeys, you can remove the batteries if necessary.
... the scale displays a weight after being transported or after new batteries have
been put in?
– Wait until the scale switches off automatically after 2 minutes. The scale will then work
normally again.
...
0.00 does not appear before weighing?
– Start the scale again after it switches off automatically - there should not be any load
on the scale.
... ---- appears instead of 0.00 before weighing?
– Start the scale again after it switches off automatically - there should not be any load
on the scale.
… one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
… the display shows ?
– Battery voltage is running low. Change the batteries in the next few days.
…
batt appears in the display?
– Batteries are empty. Put in new batteries.
… St0p appears in the display?
– Maximum load has been exceeded.
… the display flashes?
– Take the load off the scale and start the scale again. Wait until
0.00 appears and then
weigh again.
… the display appears?
– The ambient temperature of the scale is too high or too low. Place the scale in an
ambient temperature between +10 °C and +40 °C. Wait about 15 minutes for the
scale to adapt to the ambient temperature and then weigh again.
... the display E and a number appear?
– Start the scale again after it switches off automatically. The scale will then work nor-
mally again. If this is not the case, inform Servicing.
Visit www.Balances.com Your Authorized Seca Dealer
To Next Page
Loading...
