16
7. Servicing
Your seca scale leaves the factory with an accuracy greater than ± 0.25 %. To ensure that
this degree of accuracy is maintained, the product must be carefully set up and regularly
serviced. Depending on frequency of use, we recommend servicing at intervals of 3 to 5
years. Please note that a qualified servicing agent should be used for this. If you are in
doubt, seca Customer Service will give you more information.
Changing the batteries
When or bAtt appear in the display, you should change the batteries. You need
four type AA 1.5 V batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the cover of the battery compart-
ment towards “Batterie” and open the
cover.
– Take out the holder and batteries.
– Remove the used batteries and insert
new batteries in the holder.
Check that the polarity is correct.
– Place the holder and batteries in the
battery compartment.
– Close the cover.
– Then turn the scale back up the right
way.
Visit www.Balances.com Your Authorized Seca Dealer
To Next Page
Loading...
