FAQ - NVR can't output images
Our NVR can't output images when connected to cameras of other manufacturers.
1. Confirm whether the added IPC supports ONVIF protocol, confirm the ONVIF port of
IPC.
2. Confirm whether the IP address of IPC and NVR are in the same LAN and in the same
network segment.
3. Confirm that the maximum supported resolution of the channel is greater than the
resolution resolution of the current IPC.
4. If NVR channel management prompt password error, contact IPC camera manufacturer
to confirm the camera password.
5. Confirm the NVR channel status to see if the channel is connected and the resolution
has been recognized.
6. The channel is connected, the resolution is unknown, confirm whether the front-end and
back-end firmware have been updated;
7. Restore the default setting of the NVR, add the IP camera again, or you can try to add it
manually.
8. I have tried the above problems and solutions, contact Seculink Technology.
FAQ: Connect Hikvision or Dahua Camera
Prompts wrong password when connecting Hikvision or Dahua camera
1. After upgrading the password of Hikvision device, it must be more than 8-digit
password (mixed numbers and letters). Access Hikvision's camera, the security service
setting, cancel the illegal login authentication.
2. Login Dahua's camera, network settings-connection-onvif-login verification, turn off it.
To Next Page
Loading...
