9.3. Video Loss
When the recorder cannot obtain the video signal transmitted by the front camera, the
video loss alarm is activated and the linkage function is activated.
Like motion detection, the video loss function of the hybrid mode/full analog channel and
the full digital channel is different: the digital channel video loss alarm function not only
needs to be turned on at the local end, but also the corresponding remote device end
connected to the channel. To enable the video loss function, when the video
corresponding to the remote device end has video loss, the local end can realize its alarm
function. Otherwise, the video loss alarm function cannot be realized, and the analog
channel only needs to turn on the video loss of the recorder.
Frequently Asked Questions (FAQ) of Seculink Network Video Recorder
To Next Page
Loading...
