Enter the DNS Address to issue the DHCP clients. If this field is left blank, the
SnapGear unit’s IP address is used. Leave this field blank for automatic DNS server
assignment. If your SnapGear unit is configured for DNS masquerading, you should
either leave this field blank, or enter the IP address of the LAN port of the SnapGear
unit.
Optionally enter a Domain Name suffix to issue DHCP clients.
Optionally enter the IP address of the WINS server to be distributed to DHCP clients
in the WINS Address field.
Enter the Default Lease Time and Maximum Lease Time in seconds. The lease
time is the time that a dynamically assigned IP address is valid before the client must
request it again.
Enter the IP address or range of IP addresses (see the appendix entitled IP Address
Ranges) to be issued to DHCP clients in the Address Range field.
Click Finish.
DHCP addresses
To view the status of the IP address the DHCP server is configured to distribute, click the
Edit icon next to the appropriate network interface, then click the DHCP Addresses tab.
Address list
For each IP Address that the DHCP server is managing, the Status, Hostname, and
MAC Address are displayed.
119
Network Setup
To Next Page
Loading...
